Despatch MIC1462 Controller Manual - Manual (Page 30)

26
3.6 Power Up Procedure
Verify all electrical connections have been properly made before applying power to the
instrument.
If the instrument is being powered for the first time, it may be desirable to disconnect
the controller output connections. The instrument will be into control following the
power up sequence and the output(s) may turn on. During Power up, a self-test
procedure is initiated during which all LED segments in the two front panel displays
appear and all LED indicators are on. When the self-test procedure is complete, the
instrument reverts to normal operation.
Note: When power is first applied, a delay of approximately 3 seconds will be seen
before the displays light up.
3.7 Keypad Operation
MODE Key - Cycles through modes available in the instrument.
SCROLL Key - Displays the next parameter in sequence (indicated by
Message display).
UP Key
Increments displayed parameter value/cycles through options.
DOWN Key
Decrements displayed parameter value/cycles through options.