Despatch MIC1462 Controller Manual - Manual (Page 38)

34
3.21 Viewing Program Progress/Status
In Program Run Mode, a number of displays are made available to the operator (in the
Message Display area) which indicate program progress/ status. While the current
program is running, held or delayed, press the SCROLL key to cycle through a
sequence of program status displays with the following legends in the Message Display:
In the case of Segment Time Remaining or Deviation-Hold Time display, the time is in
hours/minutes (if the x60 indicator is OFF) or minutes/seconds (if the x60 indicator is
ON). The Delay Time display is always in hours/minutes.
Note: If the SCROLL key is held for two seconds or longer the instrument will auto-
scroll through the above display cycle (with the exception of the Self-Tune and Pre-
Tune displays). The auto-scroll can be stopped by pressing any key other than the
SCROLL key.