Despatch MIC1462 Controller Manual - Manual (Page 45)

41
SECTION 6: PROFILE SET MODE
The instrument may be put into Profile Set Mode from either Base Mode or Program
Run Mode (i.e. with a program currently running). This mode allows editing or viewing
of a program profile.
6.1 Entry Into Profile Set Mode
To enter the Profile Set Mode from Base Mode:
1.
Press the MODE key until PROF PAR appears in the message display
2.
Press the SCROLL key to enter the Profile Set Mode.
To return to Base Mode:
1.
Press the MODE key until Basemode appears in the message display.
2.
Press the SCROLL key to return to Base Mode.
In Profile Set mode, the operator will be presented with the first of a sequence of
parameter displays. The operator may then step through the sequence, using the
SCROLL key. The parameter setting (in the lower Main Display) may be changed using
the UP/DOWN keys. The displayed Program Number may be changed using the
PROF key and the displayed Segment Number may be changed using the RUN/HOLD
key.
The instrument may be fitted with an optional internal 24 hour clock. This clock
provides the time period information for the power fail recovery feature (see section 6)
and permits a program profile to be started at a specific time of day.
Profile Set Mode parameters are divided into three categories:
a)
GLOBAL - Those common to all programs
To view the parameters in the Global category, press the PROF key until the Program
Number shown is "A". Press the RUN/HOLD key until the Segment Number shown is
blank.