Atop Technology SE5416A User manual User Manual
Page 73
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
73
Figure 7.2
For setting as a TCP Server, please follow these steps.
Click on the COMX link under Serial on the left hand side.
Select TCP Server in the Link Modes; TCP Server is the default link mode. Also in this
section you will find the following options.
Mode, there are 3 different communication modes here:
RAW, there is no protocol on this mode, meaning the data is passed
transparently.
Virtual COM, the Virtual COM protocol is enabled on the device to
communicate with a virtualized port from the client. It is possible to create a
Virtual COM port on Windows/Linux in order to communicate with the device
as a Client.
Reverse Telnet, used to connect the device and another serial device
(usually a Terminal Server) with a Telnet program. Telnet programs in
Windows / Linux usually require special handshaking to get the outputs and
formatting show properly. The SE5416A Series will interact with those special
commands (CR/LF commands) once Reverse Telnet is enabled.
Enter the Local Port, this option specifies the port number that the server should listen to;
it is used by the client to connect to the server. Default local port is 4660.
Go to
for more information on this setting. For serial settings, go to