5 alert settings, 1 email settings, Alert settings – Atop Technology SE5416A User manual User Manual
Page 40: Email settings

Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
40
5.5 Alert Settings
Click on the
“Alert” link to open its submenu and E-mail settings.
Figure 5.17
5.5.1 Email Settings
In case the device raises an alert and/or warning message, it will send an email to the
administrator’s mailbox. Email Settings allows you to set up the device to be able to send an
email. To set up the email sending, you need to put a
“Sender” email address which will be
the
“From” on the email. Then, you fill in “Receiver” email address to which the email is sent.
You can send the email to several recipients using Semicolon (;) to separate each email
address. Next step is to set the Email Server. First, you fill in the IP address of a Mail Server
in your local network. If the Mail Server needs a user authentication, you need to enable
“SMTP server authentication required”, and fill in Username and Password. Please
contact your network administrator for Mail Server IP address and the Username and
Password,
Note: You can click on the
“Send test Mail” button to verify your mail settings.
Figure 5.18