2 dns settings, 3 snmp settings, Dns settings – Atop Technology SE5416A User manual User Manual
Page 60: Snmp settings

Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
60
Note: It is not possible to configure LAN1 or LAN2 when bridge mode is enabled. Please go to
the Bridge Settings instead.
6.5.2 DNS Settings
You can configure the DNS1 or DNS2 Server IP Address manually. Alternatively, if you enable
the DHCP option in “LAN 1 Settings”, SE5416A Series will retrieve the DNS server address
from the DHCP server automatically.
Operation: Main
→ [2]Networking → [3]DNS Settings
Figure 6.6
6.5.3 SNMP Settings
SE5416A Series allows the user to Enable or Disable the SNMP function. The changes will
become effective immediately. Basic SNMP configurations such as Read/Write Community,
SysName (System Name), SysLocation (System Location), SysContact (System Contact),
and SNMP Trap Server IP are supported.
Operation: Main
→ [2]Networking → [5]SNMP Settings