Apple Workgroup Server 8550 - Manual (Page 26)

3 If you want to specify a MacIP server in a particular zone, click Select
Zone to choose the zone of the MacIP server you want to use.
Otherwise, go to step 6.
4 In the dialog box that appears, choose the zone in which your MacIP
server is located.
5 Click OK to close the dialog box.
6 Close the TCP/IP control panel.
Your TCP/IP configuration information is obtained from the MacIP server
the next time you open a networking connection (for example, by opening a
networking application, such as Netscape, Eudora, or NCSA Telnet).
If, after configuring your TCP/IP control panel, you see an error message
such as “Unable to locate host” or “Could not create a socket,” your
software is unable to reach the network. This indicates a problem in the
TCP/IP configuration. For troubleshooting information, see Chapter 7.
26
Click here if the MacIP server is in the
same zone as your Workgroup Server.
Click here to display only those zones that have
MacIP servers. It may take a few moments for this
box to become available because TCP/IP searches
for MacIP servers in all zones first.
Click here to choose
a different zone.