Poison Spyder CJ-7 FULL CAGE KIT - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • CJ-7 FULL CAGE KIT INSTALL Page 2
©2011 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
1. Park vehicle on a level surface and set
the emergency brake. You will want to
wear eye protection beyond this point.
2. Remove any existing hard top, soft top
and associated bracketry, front seats, roll
bar or cage, and spreader bars if present.
Save any bolts that mounted the OE roll
bar to the floor, as these may be re-
used during the install of the new Poison
Spyder cage. Place welding blankets or
some sort of protective covering over the
Jeep’s dash and interior to protect it from
weld splatter.
3. If your Jeep uses knobs with large
handles to bolt the windshield in place,
you will need to remove these and
replace them with a standard bolt in order
to install the cage as close to the dash/
windshield as possible.
8 8
11 11
4
18
2 2
3 3
14 14
17
10
16 16
12
15 15
1 1
PARTS LIST
(2) A-Pillar Mount Plate L&R 1
(2) B-Pillar Mount Plate L&R 2
(2) C-Pillar Mount Plate L&R 3
(1) A-Crossbar 4 (tube unmarked)
(2) Main Side Hoop L&R 8
(1) C-Hoop 10
(2) B-Pillar L&R 11
(1) B-Crossbar 12
(2) C-Pillar L&R 14
(2) Forward Stringer L&R 15
(2) Rearward Stringer L&R 16
(1) Seat Belt Bar 17
(1) Dash Bar 18