Brother MFC7150C - Manual (Page 41)

26
C H A P T E R T H R E E
■ Brother coated (ink jet) paper is coated only on one side. Make sure
this whiter (coated) side is facing up toward you. Therefore, when
loading paper in the paper cassette, make sure that the whiter side (the
coated side) is facing up.
■ The coated side of glossy paper is shiny. Do not touch the shiny side.
Load glossy paper in the feeder with the shiny side facing up toward you.
■ DO NOT touch the coated side of the paper or both sides of
Transparencies, because it absorbs water and perspiration easily, and
might cause decreased output quality.
■ For optimum output quality, be sure to use paper appropriate for your
resolution setting.
■ Store paper in the original bag, and keep it sealed. Keep the paper flat
and away from moisture and direct sunlight and heat.
■ Transparencies designed for laser printers/copiers may stain your next
document. Use only recommended transparencies.
Paper Specifications for Casette and Manual Feed Slot
Paper Type Paper Size Cassette Capacity
Cut Sheet Letter, Executive 200 Sheets of 20 lb(75 g/m 2 )
Legal 100 Sheets of 20 lb(75 g/m 2 )
Coated Paper Letter 100 Sheets
Transparencies Letter 20
Glossy Paper Letter 20
Envelopes DL, COM-10, C5, 10
B5, Monarch
Organizer J(Manual Feed Slot Only), K, L 10
Paper Capacity for Feeder
Cut Sheet Paper Weight 16 to 32 lb (60 to 120 g/m 2 )
Sheet Feeder: Up to 0.87 inches (22mm) / Approximately 200 sheets of 20 lb
(75 g/m
2 )
Output Stacker: Approximately 75 Sheets of 20 lb (75 g/m 2 )
Transparencies and glossy paper must be picked up from the paper tray one page at
a time.