Brother HL-2400Ce User Manual

Page 165

Text mode
Original mode

USER’S GUIDE

5-18

✒ Note
If you begin using a new Fusing Unit immediately, poor print quality may
result. Please wait for 30 minutes after installing a new Fusing Unit to
allow the oil to circulate completely through to the Heat Roller.

4. Remove the Fusing Unit from the printer by holding the handles on

both sides.

Fig. 5-21 Removing the Fusing Unit

Caution

When removing the Fusing Unit from the printer, be sure to keep the
Fusing Unit flat, so oil will not spill. Considerable damage can occur if
oil is spilled inside the printer.

5. Remove the Oil Bottle and the Fuser Cleaner from the Fusing Unit.

6. Install the new Fusing Unit into the printer. Be sure to insert the

Fusing Unit completely into the printer.

Fig. 5-22 Installing the New Fusing Unit