Konica Minolta bizhub 420 - Manual (Page 218)

Setting Up the KONICA MINOLTA PS Driver (Windows) 6
IC-204 6-34
Bitmap Compression
Set whether or not to use the Bitmap compression. Using this function when
much image data should be printed, the printing speed may be improved.
1
Click the PostScript tab.
2
Select “RLE”, “LZW” or “JPEG” from the “Compress Bitmap” pull
down list in the setting.
– If you select “JPEG”, then you can select the JPEG compression
type from the “JPEG” pull down list.
Using Tokenised PS
Set whether or not to use Tokenised PS.
1
Click the PostScript tab.
2
If you use the Tokenised PS, select the “Tokenised PS” checkbox in
the setting.
Setting the Output Protocol
Set the output protocol as follows.
1
Click the PostScript tab.
2
Select “Pure Binary” or “ASCII” from the “Output Protocol” pull down
list in the setting.
Setting the Gamma
Set the gamma correction value as follows.
1
Click the PostScript tab.
2
Set the gamma correction value from the “Gamma Level” pull down list
in the setting.
– Setting range is 0.000 - 2.000.