Konica Minolta bizhub 200 - Manual (Page 94)

Setting up network printing 3
200/250/350 3-35
5
To apply the settings, restart this machine (turn the main power off,
then on again).
2
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.
Setting the Macintosh computer
Use the Macintosh computer that is connected to specify the TCP/IP and
AppleTalk settings.
2
Note
For network settings, consult the network administrator.
For printer driver installation, refer to “Installing the printer driver” on
page 2-1.
For Mac OS X
1
On the Apple menu, select “System Preferences”.
2
Click the “Network” icon.
3
From “Show”, select “Built-in Ethernet”.
4
Click the TCP/IP tab.
5
Select the items from “Configure” that correspond to the network set-
tings for the Macintosh computer that is connected to the network, and
then set the IP address and subnet mask.
6
If using an AppleTalk connection, click the AppleTalk tab, and then
check that the “Make AppleTalk Active” check box is selected.
7
Click the close button at the top left of the dialog box.
The “Apply configuration changes?” message appears.
8
Click the [Apply] button.
The AppleTalk and Ethernet settings are saved.