Konica Minolta bizhub C650 - Manual (Page 66)

C650 2-39
Scanning 2
2
Touch [PC (SMB)] on the Direct Input screen.
A screen appears, allowing you to type in the host name for the destination and the file path.
? Why is the Direct Input tab not displayed?
% If the "Manual Destination Input" (displayed by touching [Security Settings] on the Administrator
Settings screen, then [Security Details]) is set to "Restrict", the Direct Input tab does not appear.
3
Enter the information for the destination, and then touch [OK].
– To check the contents of the shared folders, and then touch [Reference].
– To specify an additional address, touch [Next Destination], and then enter the information.
The entered addresses appear under "Broadcast Destinations".
4
Touch [Scan Settings], [Original Settings] or [Communication Settings], and then specify the desired
scan settings.
– For details on the scan settings, refer to "Specifying scan and transmission settings (Scan
Settings/Original Settings/Communication Settings)" on page 2-53.
5
Load the document into the ADF or place it on the original glass.
6
If desired, press the [Proof Copy] key to check a preview image.
– For details, refer to "Sending after previewing" on page 2-15.
7
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
2
Note
Do not turn off the machine until the scan job is deleted from the Job List screen.