Konica Minolta bizhub C650 - Manual (Page 136)

C650 3-15
Specifying Utility mode parameters 3
– The icons are used in the image panel function which can be operated when the optional i-Option
LK-101 or i-Option LK-103 is installed.
19
Touch [OK], and then touch [OK] in the next screen that appears.
The SMB destination is registered.
!
Detail
To check a registered destination, select it, and then touch [Check Job Set.].
To change the settings for a registered destination, select it, and then touch [Edit]. The registration
number cannot be changed in the Edit screen.
To delete a registered destination, select it, and then touch [Delete].
If the computers or workgroups on the network (subnet) that this machine belongs to is more than the
numbers listed below, browsing over the network may not be performed correctly.
Workgroups: 128
Computers: 128
Also, browsing is not available in the IPv6 environment.
2
Note
The registration cannot be completed if no settings are specified for "Name", "Host Address" and "File
Path".
To cancel the registration, touch [Cancel].
To finish specifying settings in the Utility mode, press the [Utility/Counter] key. Otherwise, exit the Utility
mode by touching [Close] in each screen until the screen for the Copy, Fax/Scan or Box mode appears.
FTP
Settings can be specified for the following for the FTP destination to be registered.
Parameter Description
No. Type in the registration number (between 1 and 2000) for the address book destination. If noth-
ing is entered when [OK] is touched, the destination is registered with the lowest available
number.
Name Type in a name of 24 characters or less for the registered destination.
Host Address Type in the host address in the format of a host name, IPv4 address or IPv6 address.
For a host name, type in 63 characters or less.
File Path Type in 96 characters or less for the path to the saved file.
User ID Type in 47 characters or less for the user ID for logging onto the host computer.
Password Type in 31 characters or less for the password for logging onto the host computer.
anonymous To specify no user ID for logging onto the host computer, touch [ON].