Selecting a group destination, Selecting a group destination -28, P. 2-28 – Konica Minolta bizhub C650 User Manual
Page 55
C650
2-28
Scanning
2
3
Touch a destination button to select the address.
–
Multiple destinations can be specified at the same time.
–
Additional destinations can be added by directly typing in the address.
The button appears selected, and the destination appears under "Broadcast Destinations".
4
Touch [Scan Settings], [Original Settings] or [Communication Settings], and then specify the desired
scan settings.
–
For details on the scan settings, refer to "Specifying scan and transmission settings (Scan
Settings/Original Settings/Communication Settings)" on page 2-53.
5
Load the document into the ADF or place it on the original glass.
6
If desired, press the [Proof Copy] key to check a preview image.
–
For details, refer to "Sending after previewing" on page 2-15.
7
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
2
Note
Do not turn off the machine until the scan job is deleted from the Job List screen.
Selecting a group destination
"Group" refers to multiple destinations that are registered collectively. The description below describes the
procedure for specifying the group and sending the data, starting from the situation where "Address Book
default" has been set to "Address Type" in [Custom Display Settings] in the User Settings screen.
For details on registering group destinations, refer to "Registering a group destination" on page 3-23.
!
Detail
For details on screen display, refer to "Default Address Book" on page 3-34.
1
Press the [Fax/Scan] key in the control panel.
The Fax/Scan mode screen appears.