Closed network rx, Forward tx setting, Closed network rx -23 forward tx setting -23 – Konica Minolta BIZHUB C652DS User Manual
Page 212: P. 10-23)
bizhub C652/C652DS/C552/C552DS/C452
10-23
10.4
Administrator Settings (G3)
10
Closed Network RX
Specify whether to use the Closed Network RX function. To use the function, specify a password that is used
for Closed Network RX.
Press [No] to clear the entered setting and then specify a password using the keypad. (up to 4 digits)
Reference
-
Closed Network RX is only available when the receiver has password transmission function.
Forward TX Setting
You can forward received documents to a preset recipient. The items that are to be configured are listed
below.
If two units of the fax kit FK-502 are installed, and [Individual Receiving Line Setup] is set to [ON] in
Administrator Settings, you can select either [Fax Line 1] or [Fax Line 2] to configure settings for each line.
For details on [Individual Receiving Line Setup], refer to page 10-18.
The following items are not available if Forward TX Setting is configured.
-
PC-Fax RX Settings
-
TSI User Box Settings
-
Memory RX Setting
Item
Description
Output Method
Forward & Print: Received document are forwarded and printed on this ma-
chine.
Forward & Print (If TX Fails): Received documents are forwarded and, if for-
warding fails, are printed on the machine.
Forward Dest.
Allows you to enter a fax number using up to 38 digits. It is also possible to
select it from the address book.
Select Line
If two units of fax kit FK-502 are installed, this setting can be specified for
each line.