Kramer Electronics VS-3232V - Manual (Page 45)

The MENU Commands
41
8.7 The Main Firmware Version
The main firmware version menu shows information regarding the latest main
and Ethernet firmware versions, for example:
> ? (&''
? 5 9 :& :
This information lets you decide whether a firmware upgrade is required.
It is recommended to upgrade the firmware only after consulting with the
Kramer technical support staff
8.8 Selecting the TOTAL RESET Option
The TOTAL RESET options requires you to press the blinking TAKE button
twice for double confirmation. Table 11 summarizes the TOTAL RESET
menu options:
Table 11: Total Reset Menu
Press: To select: After the change, the LCD displays:
1 All outputs OFF , to
disconnect all the outputs
MATRIX erased
2 Factory default , to the
factory default state
The Machine resets as follows:
OUT 1 is connected to IN 1, OUT 2 is connected to IN 2 … OUT 31
is connected to IN 31 and OUT 32 is connected to IN 32
The SYNC is extracted from the BNC-Genlock Input
All the interfaces are set to ON
The interface Reply is set to Reply
The interface protocol is set to Hex Kramer-2000
The DEFAULT SETUP is set to Matrix setup and cross-points