Kramer Electronics VS-3232V - Manual (Page 39)

Operating Your Video Matrix Switcher
35
2. Press the DEFAULT SETUP button a second time to recall the default setup.
The DEFAULT SETUP button stops blinking and no longer illuminates, the
TAKE button blinks and the following message appears on the LCD display:
:
9
3. Press the TAKE button to confirm the action or press the ESC button to cancel
the operation.
If the DEFAULT SETUP was recalled, the DEFAULT SETUP button
illuminates.
7.7 Choosing the FOLLOW or the BREAKAWAY Modes
When the VS-3232V functions in the:
FOLLOW-System mode, the VS-3232V switches with other 32x32 or
16x16 matrix switchers, implementing the same action simultaneously
BREAKAWAY-from-System mode, the VS-3232V functions
independently, implementing an action as a stand alone unit that is
independent of the other units connected
The VS-3232V unit will function in the FOLLOW-System mode if at least
one other VS-3232V unit is set to the FOLLOW-System mode and these units
interconnect via an RS-232 and/or RS-485 communication line.
To set the
VS-3232V unit to function in the FOLLOW-System mode:
1. Press the FOLLOW button.
The FOLLOW button blinks and the LCD display shows the following
message:
; <
6 7 8 9
2. Press the FOLLOW button once again.
If there are no switchers online in the FOLLOW-System mode or if one or
more switchers that are in the FOLLOW-System mode are online but their
cross-points status is exactly the same as that of the VS-3232V, the VS-3232V
immediately moves to the FOLLOW System mode.
The FOLLOW stops blinking and then illuminates, the BREAKAWAY
button no longer illuminates and the LCD display restores its last content.