Kramer Electronics VS-3232V - Manual (Page 35)

Operating Your Video Matrix Switcher
31
7.4.1 Switching one Input to one Output
To switch one input to one output (in the At Once mode):
1. Press the appropriate digit buttons (for example, 06 representing output 6).
The LCD display shows the following on the right side:
/ / 01 '+
The left-hand side of the display shows a segment of the input-output display,
automatically shifting the content to show the 06 output.
2. Press the appropriate input number (for example, 27 representing input 27):
When in the At Once mode, the switching takes place immediately
and the LCD display shows a segment of the input-output status,
including the switched input and output (for example 06-27)
When in the Confirm mode, the LCD display shows the following:
#, 01 '+
Press the blinking TAKE button to switch the input to the output
7.4.2 Switching several Inputs to several Outputs
In the At Once mode, the VS-3232V will execute each OUT-IN combination
separately (see section 7.4.1). If you want to switch several inputs to several
outputs it is necessary to operate the machine in the Confirm mode.
In the Confirm mode you can key-in several actions and then confirm them by
pressing the TAKE button once (simultaneously switching several inputs to
several outputs).
To switch several inputs to several outputs in the Confirm mode (the TAKE
LED is illuminated), do the following:
1. Press the appropriate digit buttons for an out-in combination.
The TAKE button blinks.
Key-in additional output-input combinations.
The LCD display can show up to five keyed-in actions, as follows 1 :
'. 01 '+ '* 01 ',
2. After completing the output-input switching sequence, press the blinking
TAKE button to carry out the switching operation.
The inputs switch to the respective outputs, as shown on the LCD display and
the TAKE LED no longer blinks and remains illuminated.
1 In this example, input 9 is set to switch to output 06 and input 5 is set to switch to output 7