Kramer Electronics VS-3232V - Manual (Page 34)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Video Matrix Switcher
30
In the Confirm mode (the TAKE button illuminates):
You can key-in an action and then confirm it by pressing the TAKE
button
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action 1
7.3.1 Toggling between the At Once and Confirm Modes
To toggle between the At Once and Confirm modes, do the following:
1. Press the TAKE button to toggle between the At Once mode (in which the
TAKE button does not illuminate) and the Confirm mode (in which the
TAKE button illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the Confirm mode back to
the At Once mode.
Actions no longer require user confirmation and the TAKE button no longer
illuminates.
You can toggle between the At Once and Confirm modes at any time, unless
the TAKE button blinks.
7.3.2 Confirming a Switching Action
To confirm a switching action (in the Confirm mode), do the following:
1. Press an OUT-IN combination.
The TAKE button blinks.
2. Press the blinking TAKE button to confirm the action.
Once the action is executed, the TAKE button illuminates once again.
7.4 Switching Options
You can switch:
One input to one output (see section 7.4.1)
Several inputs to several outputs (see section 7.4.2)
One input to all outputs (see section 7.4.3)
1 Failure to press the TAKE button within half minute (the Timeout) will abort the action