Shield assembly, Jackshaft bearing support assembly, Assembly – Alamo FC-0016 User Manual

Page 94: Assembl y

ASSEMBLY

A96B 03/06

Assembly Section 3-10

ASSEMBL

SHIELD ASSEMBLY

Remove and discard the two top bolts from the Center Gearbox. Attach Bracket (1) to the Center Gearbox with

M10 x 40 Bolts (2), and Flatwashers (3) in the same hole location. Install Shield (5) and retain with 1/2” Wing

Nut (4) (Figure ASM-R-0147).

JACKSHAFT BEARING SUPPORT ASSEMBLY

Attach the Jackshaft bearing support bracket (1) to

the tongue. Loosely attach bearing support by using

pivot bolt (3) with bushing (6). Install Bearing and

housing assembly (4). Install spacers (5) and bolt

(2) leaving installed loosely. Tighten bolt (2) NOTE:

Do not tighten to point of collapsing spacer (5).

Tighten pivot bolt (3) NOTE: Do not over tighten.

Make sure Carrier Bearing (4) pivots in supports

and complete assembly pivots on lower bolt. Slide

Jackshaft through bearing (4) slide spacer (7) on

Jackshaft (NOTE: Spacer goes between bearing

and Quick Disconnect Yoke.) See parts pages for

Jackshaft Bearing Support prior to Serial # 10705.

(Figure ASM-R-0148)

NOTE: Bearing should be pressed or locked
in place using loctite on jackshaft when shipped. If

not apply locktite 609 to shaft when installing

bearing.

This manual is related to the following products: