beautypg.com

Assembly instructions for gearbox, Assembly instructions for gearbox -21, Maintenance – Alamo FC-0016 User Manual

Page 163

background image

MAINTENANCE

A96B 03/06

Maintenance Section 5-21

© 2006 Alamo Group Inc.

MAINTENANCE

ASSEMBLY INSTRUCTIONS FOR GEARBOX

Step 1. Install bearing cups into lower end of main housing. Using appropriate tool, install first cup, then

spacer, and then last cup. Note: Apply Locktite #270 to cups before installing. Note direction of cups when

installing. See crossection view Figure Mnt-R-0127.

Step 2. Apply Locktite #270 to cone bore and press bearing cone on output shaft against shoulder at lower

end. Insert shaft assembly into bottom of main housing. Install top bearing inserting over end shaft inside main

gearbox housing. Install gear spacer. Install Gear Adjusting Shims, if any were present at disassembly. Install

the Output Gear on the Output Shaft. Figure Mnt-R-0128.

Step 3. Install special flat washers and special lock washer. Apply locktite to nut threads and threads on shaft.

Figure Mnt-R-0129.

This manual is related to the following products: