Seasonal clutch maintenance, Mark outer plates as shown in figure mnt-r-090, Seasonal clutch maintenance -10 – Alamo FC-0016 User Manual
Page 152: Maintenance
MAINTENANCE
A96B 03/06
Maintenance Section 5-10
© 2006 Alamo Group Inc.
MAINTENANCE
SEASONAL CLUTCH MAINTENANCE
It is important that the clutches slip when an obstacle or load heavier than the clutch setting is encountered.
Therefore, if the machine sits outside longer than 30 days and is exposed to rain and/or humid air it is
important to make sure that the clutch lining plates are not rusted/corroded together. Before using the cutter
use the following procedure to make sure the clutch will slip and give the overload protection required.
1.
Loosen nuts (Figure Mnt-R-090) on springs until the springs can freely rotate, yet remain secure on
bolts.
2.
Attach cutter to tractor and start the tractor. Set the engine speed at 1200 RPM.
3.
Mark outer plates as shown in Figure Mnt-R-090.
4.
Engage the PTO (approximately one second) and then quickly disengage it. The friction lining plates
should break loose (check the mark).
5.
Turn tractor off and tighten the nuts on the springs to their original position of 1-9/16” compressed
spring length.