Wheels - pull type, Driveline attachment, Wheels - pull type -9 driveline attachment -9 – Alamo FC-0016 User Manual
Page 93: Assembly, Assembl y
ASSEMBLY
A96B 03/06
Assembly Section 3-9
© 2006 Alamo Group Inc.
ASSEMBL
Y
WHEELS - PULL TYPE
Install the Wheels on the Wheel Hubs. Note: If Laminated Tires are used, place the flat side of the Lug Nut
against the Wheel Figure ASM-R-0146. Note direction of travel and curvature of rubber segments in tire and
install as shown in Figure ASM-R-0146.
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. (Figure ASM-R-0118)
1.
Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip
clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the
proper torque. Refer to Torque Chart in Maintenance Section.