Bearing driver, Gasket sealant, Impact wrench – Alamo FC-0016 User Manual
Page 159: Chisel 3/16” wide blade, Sledge hammer, Ball pin hammer, Socket wrench, Screw driver, Punch - long drift, 14mm socket
MAINTENANCE
A96B 03/06
Maintenance Section 5-17
© 2006 Alamo Group Inc.
MAINTENANCE
1.
Bearing Driver
2.
Gasket Sealant
3.
Impact Wrench
4.
Chisel 3/16” Wide Blade
5.
Sledge Hammer
6.
Ball Pin Hammer
7.
Socket Wrench
8.
Screw Driver
9.
Punch - Long drift
10.
14mm Socket
11.
17mm Socket
12.
Pry Bar
13.
Locktite #270
Be certain to clamp or securely support the gearbox and sub-assemblies to prevent injuries
to hands and feet due to inadvertent dropping or falling over.
Always wear safety glasses and gloves to prevent eye and hand injury when chiseling or
hammering on metal components. Hardened metal will chip unexpectedly.
An assembled gearbox is quite heavy. Use a hoist or get help to handle them safely. Lift
carefully and properly using your legs to lift - not your back.
NOTICE:
Refer to operator’s manual for instructions for proper re-assembly onto the mower deck.
Tighten correctly.