Alamo FC-0016 - Manual (Page 165)

MAINTENANCE
A96B 03/06 Maintenance Section 5-23
© 2006 Alamo Group Inc.
MAINTENANCE
Step 5 Place output cap on the output shaft and check the gap between housing and cap to see how many
gaskets will be required. Remove the output cap and install the gaskets. A small bead of sealant should be
applied on top of the gaskets and around the flange of the cap. Reinstall the cap and gasket assembly on the
Housing, install the 4 Bolts and tighten them to a torque of 75 to 79 Foot Pounds. Figure Mnt-R-0130.
Step 6 Install rear input shaft bearing cup in back side of main housing.
Step 7 Install Bearing on the Input Shaft and then place Shaft into the Housing. Next install the Gear Spacer on
the Shaft. Reinstall the Gear Adjusting Shims on Shaft and the Input Gear. Check the back side of the Gear
Tooth surface where the Input and Output Gear engage each other. These two surfaces should be
approximately flush. If they are not approximately flush, then either add or subtract shims under the output
Gear or in front of Input Gear. Figure Mnt-R-0131. NOTE: Gear, Spacer, and Shims are located on opposite
end of Shaft for Right Wing Gearbox.