Alamo FC-0016 - Manual (Page 86)

ASSEMBLY
A96B 03/06 Assembly Section 3-2
© 2006 Alamo Group Inc.
ASSEMBL
Y
The A96B Mower will attach to most tractors with Cat. II and lII Quick Hitch. The A96B can be purchased for
tractors with 540 or 1000 RPM PTO.
DEALER SET-UP INSTRUCTIONS
Assembly of this mower is the responsibility of the Alamo dealer. The mower should be delivered to the owner
completely assembled, lubricated, and adjusted for normal cutting conditions.
Set up mower as received from the factory with these instructions. Open parts box and lay parts out to make
location easy. Refer to the parts lists and exploded view drawings for more detail.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware.
Always use personal protection devices such as eye, ear and feet protectors during
assembly.
A-FRAME ASSEMBLY-LIFT TYPE
1. Insert bushing (5) into lower end of each A-Frame half (1 & 2). Position each A-Frame half so the large
hole in the top is towards the tractor. Install 3/4” x 2" bolt (10) with Flatwasher (14) through bushing (5) in
A-Frame half (1 & 2) and rear hole in inside Main Frame lug. Install locknut. (Figure Asm-R-0134)
2. Install bushing (8) between A-Frame halves (1 & 2) through lower front hole and retain with bolt (12) and
locknut (13).
3. Install bushing (8) between A-Frame halves (1 & 2) at upper rear hole location. Install bushings (6) through
Braces (3) and install bolt 3/4” x 5" (9), flatwashers (14) and locknut (13) through all parts as shown. Note:
Rear braces (3) install to outside of A-frame halves.
4. Attach Braces (3) to Braces (4) with bushings (6), flatwashers (14), bolt 3/4” x 2-1/2” (16), and locknut (13).
Retain the rear of Braces (3) together with bushing (15), bolt 3/4” x 2-1/2” (11) and locknut (13) through
middle holes in brace (3). Attach braces (4) together with bolt 3/4” x 1-1/2” (17) and locknut (13).
5. Install rear braces (4) to the rear lugs on the Main Frame with bolts 3/4” x 2" (10), flatwashers (14), bush-
ings (6) and locknuts (13).