beautypg.com

Gearbox, Tail wheel assembly, Gearbox -3 tail wheel assembly -3 – Alamo FC-0016 User Manual

Page 145: Maintenance

background image

MAINTENANCE

A96B 03/06

Maintenance Section 5-3

© 2006 Alamo Group Inc.

MAINTENANCE

GEARBOX

The Gearbox has been filled with lubricant to the Test Plug Level prior to shipment. However, you should check

the oil level at Test Plug before operating, and frequently thereafter.

The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is

recommended that the oil level plug be removed after every 8 to 10 hours of operation and oil added until it

runs out Test Plug hole. The Test Plug is located on the rear of the Gearbox. Filler Plug is located on top of

Gearbox. Figures Mnt-0001, MntP-R-0025 & Mnt-R-0117.

Required lubricant is NLGI 000 Grease (P/N 00769030).

NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.

ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill

Gearbox as required.

TAIL WHEEL ASSEMBLY

Tail Wheel Bearings are packed at the factory with

heavy-duty bearing grease. Grease Fittings are

provided in the Wheel Hub and Tail Wheel Beam.

Grease after every 10 hours of use. Figure Mnt-R-

0101.

OFFSET MODEL

STANDARD LIFT AND PULL

TYPE MODELS

This manual is related to the following products: