ADTRAN MX410 - Manual (Page 52)

Logging in to the MX410/MX412 MX410/MX412 System Manual
5-2 PRELIMINARY 61189500L1-1B
– no parity (none)
– one stop bit
– no flow control
2. Set the PC for direct connect on the appropriate communications port (as opposed to dial
up connection).
3. Plug the male end of the data cable into the MX410/MX412. Make connection to the PC or
laptop as appropriate for the equipment.
Telnet Session
To access the MX410/MX412, use an appropriate Telnet client to access the management
interface of the MX410/MX412 at the configured IP address.
LOGGING IN TO THE MX410/MX412
To logon to the MX410/MX412, perform the following steps:
1. Establish the physical connection to the MX410/MX412 using a craft port session or
enter the default IP address “192.168.100.1” with a subnet mask of “255.255.0.0.” to
establish a Telnet session.
2. Enter the default username “ADMIN” in all capital letters, and press E NTER
.
3. Enter the default password “PASSWORD” in all capital letters, and press E NTER
.
NOTE
Login username and password fields are case sensitive. The default
values are all uppercase.