Karcher ICC 2 D ECO 2SB STAGE IIIa - Manual (Page 41)

- 19
Troubleshooting
Fault Remedy
Appliance cannot be started Charging or replacing battery
Fill in fuel, deaerate the fuel system
Clean or replace fuel filter
Check fuel pipes, connections and joints and maintain them if required
Inform Kärcher Customer Service.
Engine is running erratically Clean or replace air filter
Check fuel pipes, connections and joints and maintain them if required
Inform Kärcher Customer Service.
Motor is overheated (visual and
sound signal) Refill coolant
Clean the cooler
Inform Kärcher Customer Service.
Engine is running but machine is
only moving slowly or is not mov-
ing at all Release parking brake
Exchange the drive direction lever
Check level of hydraulic fuel
Inform Kärcher Customer Service.
Side-brushes are rotating slowly
or not at all Increase the side-brush speed
Remove ropes and tapes
Check level of hydraulic fuel
Inform Kärcher Customer Service.
Dust gathers in the machine Switch on the water pump
Refill water
Adjust the speed of the side-brushes
Clean water nozzles
Inform Kärcher Customer Service.
Sweeping unit does not pick up
waste Reduce working area
Empty waste container
Set motor rpm correctly (1800 1/min)
Clean the suction channel
Clean the exhaust grid
Inform Kärcher Customer Service.
Waste container does not raise or
lower Check level of hydraulic fuel
Inform Kärcher Customer Service.
Operation problems with hydraulic
movement parts Inform Kärcher Customer Service.
41 EN