Karcher ICC 2 D ECO 2SB STAGE IIIa - Manual (Page 40)

- 18
 Adjust the front sealing strip (2) so that
it touches the floor.
 Tighten the fastening screws of the
sealing strip.
Replacing the sealing strip:

Loosen the screws.
 Remove the sealing strip.
 Screw on the new sealing strip.
 Drain off the suction opening.
 Adjust the sealing strip.
 Tighten the fastening screws of the
sealing strip.
 Raise waste container.
 Remove the washer.
 Clean the sealing area.
 Insert the new washer and paste the
ends using silicon.
 Raise waste container.
 Remove the washer.
 Clean the sealing area.
 Insert the new washer and paste it.
 Remove the washer.
 Clean the sealing area.
 Insert the new washer and paste it us-
ing silicon.
 Remove the washer.
 Clean the sealing area.
 Insert the new washer and paste it.
 Loosen the screws.
 Remove the headlights.
 Remove defective bulb.
 Insert new bulb.
 Loosen the screws.
 Remove the glass of the travel direction
indicator.
 Remove defective bulb.
 Insert new bulb.
 Loosen the screws.
 Remove the glass of the tail lamp.
 Remove defective bulb.
 Insert new bulb.
Note
Only use fuses with identical safety ratings.

Replace defective fuses.
 Replace defective fuses.
Note
Attachment sets for new vehicles are also
available ex-factory.
Changing the washer of the suction pipe
Changing the washer of the waste con-
tainer
Changing the washer of the turbine suc-
tion
Changing the headlight bulb
Changing the bulb of the travel direction
indicator
Replacing the bulb of the tail lamp
Replacing the fuses in the fuse box in
the driver cabin
Replacing the fuses in the fuse box of
the motor compartment
Accessories
Spare wheel, complete 6.996-001
Bush plate 6.996-002
Side brushes, plastic/ plastic 6.996-003
Side-brushes, steel plate
6.996-004
Side-brushes, PE/Steel 6.906-258
Breakdown triangle 6.996-005
Bulbs/ fuse set 6.996-006
Wheel wedge 6.996-007
Air-conditioner 2.639-614
Radio 2.639-615
Leaf suction hose 2.639-616
Overall warning lamp, rear
(only for appliances without
leaf suction) 2.639-617
Comfort seat (higher back-
rest) 2.639-618
Rear mirror, with heating 2.639-619
Battery charger 6.654-116
Central lubrication unit 2.639-635
Bumper at the rear 2.639-636
Reverse drive camera 2.639-641
Jack 6.369-518
Hose holder for filling hose 2.639-645
Safety warnings 2.639-869
Hydraulic side-brush relief 2.850-816
2. Regulation valve (for reg-
ulating the spray water
quantity separately on the
right and the left) 2.640-216
Solenoid valve (for stopping
the spray water and lifting
the brushes) 2.640-217
Attachment set for bypass
valve 2.641-197
40 EN