Karcher ICC 2 D ECO 2SB STAGE IIIa - Manual (Page 37)

- 15
 Raise waste container.
 Insert the hose on the drain screw.
 Turn the drain screw by one rotation.
 Keep a suitable catch bin ready.
 Close the release screw.
 Raise waste container.
 Loosen the fasteners of the air filter
casing.
 Remove covering lid.
 Remove and clean the filter cartridge.
 Insert new filter cartridge, if required.
 Clean the screw cap.
 Replace the screw cap and clamp it.
 Fix the fasteners of the air filter casing.
 Grease the left end right lubrication nip-
ples of the front axle.
 Grease the left end right lubrication nip-
ples of the rear axle.
 Grease the lubrication nipple at the
swivel joint.
 Grease the lubrication nipple at the
steering cylinder.
 Grease the lubrication nipple at the
steering cylinder.
 Grease the lubrication nipple at the
brush-system (8x).
Only 4-brush system:

Lift the covering flaps at the swivel
heads.
 Grease the swivel joints (8x).
Only 4-brush system:

Lift the covering flaps at the swivel
heads.
 Grease the swivel joints (8x).
The central lubrication unit automatically lu-
brications all the lubrication points at spec-
ified intervals.
Note
It is necessary to do an additional round of
greasing after the appliance has been
cleaned thoroughly.
 Press the button on the central lubrica-
tion unit.
The central lubrication unit will not lubricate
the brush-system.
 Check the V-Belt of the spray-water
pump for damage and wear and tear.
 Raise waste container.
 Check the V-Belt of the lighting system
for damage and wear and tear.
 Refill water for the wiper.
Emptying the water separator of the fuel
system
Cleaning and replacing the fuel filter
Greasing the bearings
Greasing the brush-system
Central lubrication unit (accessory)
Checking the V-Belt
Refilling wiper water
37 EN