HID Hi-O iCLASS Installation Guide - Manual (Page 47)

iCLASS OEM75 Integration Guide, 3141-907, Rev. B.0
January 2014 Page 47 of 49
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary
information, which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written
consent of HID Global Corporation. If you are an unintended recipient of this information or are unwilling to accept the above
restrictions, please immediately return this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106.
7.6 Regulatory
HID OEM Reader Modules
The following describes HID OEM Reader modules regulatory guidelines.
• UL Recognition (Recognized Component) to UL294 for the USA and CSA C22.2 No. 205
for Canada. The mark is cRUus where the “R” is backwards and “Security” appears above
the circle containing the Mark.
• OEM Final Product UL Listing
Because HID OEM Modules are cRUus recognized, UL will treat them as a recognized
component and only the remainder of the final product will need evaluation for a listing. The
mark will be cULus with “Security” written above the circle containing the mark.
• Transient surge protection (transorbs) is not provided on the OEM75.
• The OEM75 module is intended to be part of a reader. The reader in which the OEM75 is
used must translate the 3 VDC module Voh signaling to 4 to 5.5 VDC Voh SIA AC-01
(1996.10) signaling requirements.
OEM Final Product Radio Certifications
• Because HID OEM modules contain a radio transmitter operating at either 125 kHz or
13.56 MHz and the module is integrated into the OEM’s final product, Radio Certification
will be required for the final product.
• FCC Certification can be obtained by submitting the final product to a Telecommunications
Certified Body (TCB) laboratory that can perform the testing and issue the FCC Grant.
Standard: Part 15, Subpart C.
• Often the same TCB can also test to Canada requirements and grant certification as a
Certification Body (CB). Standard: RSS-210, RSS-GEN and RSS-310 where applicable
• The same laboratory may also be an EU Communications Assessment Body (CAB) that is
accredited to test to R&TTE Directive requirements for CE Marking. Standards: EN 300
330, EN 301 489-3, EN 50130-4, and IEC60950
• A laboratory that is a CAB testing to R&TTE Directive requirements will also be testing to
Australia and New Zealand requirements because of a common test standard. Standard:
AS/NZS 4268
• Asian country certifications are obtained on an individual country basis.
OEM Final Product US Dept. of Commerce Bureau of Industry and Security (BIS) approval is
required for USA based companies who export and re-export products using encryption.
Regulatory Compliance Assistance - HID Global will provide technical assistance and laboratory
recommendations as required.