HID Hi-O iCLASS Installation Guide - Manual (Page 12)

iCLASS OEM75 Integration Guide, 3141-907, Rev. B.0
Page 12 of 49 January 2014
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary
information, which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written
consent of HID Global Corporation. If you are an unintended recipient of this information or are unwilling to accept the above
restrictions, please immediately return this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106.
Note: In the following mechanical drawings, unless otherwise specified the dimensions are in
inches and [millimeters]. Tolerances are as follows:
Tolerances Definition
Angular ±1º
Bend ±1º
.XX ±.01 [.3]
.XXX ±.005 [.13]
4.1 OEM75 Module – 3141Axx
Figure 4-1: OEM75 – 3141Axx
Note: The 20mil P1, P2 and P3 holes can accept 26 AWG (0.41 mm, 0.13 mm 2 ) or 28 AWG (0.33
mm, 0.08 mm 2 ) wires.