elektraLite CP100xt Manual Part Two - Manual (Page 99)

99
This moves a single dimmer submaster assignment. The target may not already exist.
Move Dimmer Submaster Page n To n
This is an alias for Move Dimmer Page n To n.
Move Feature Preset n … To n
This renumbers specific feature presets to a contiguous range starting with a specific number. The
target may not conflict with any existing feature presets.
Move Fixture n … To n
This renumbers specific fixtures to a contiguous range starting with a specific number. The target may
not conflict with any existing fixtures.
Move Fixture Group n … To n
This renumbers specific fixture groups to a contiguous range starting with a specific number. The
target may not conflict with any existing groups.
Move Macro n … To n
This renumbers specific stored macros to a contiguous range starting with a specific number. The
target may not conflict with any existing macros.
Move Preset n … To n
This renumbers specific stored presets to a contiguous range starting with a specific number. The
target may not conflict with any existing presets.
Move Submaster p.f To p.f
This moves a single submaster assignment. The target may not already exist.
Move Submaster Page n To n
This moves a specific submaster pages. The target may not conflict with any existing assignments.
Preset
This selects the PRESET VIEWER display.
Preset n …
This copies specific presets into the cue editor as though they were cues. If Solo is on, it first clears
the cue editor; otherwise, its feature settings are combined with the existing ones. Where there are
conflicts, newer LTP feature values override older ones, and higher HTP feature values override
lower ones.
Record
If recording a chase or macro, this stops recording. Otherwise, it does nothing. (Note that this
command is executed immediately, without waiting for Enter to be pressed.)