elektraLite CP100xt Manual Part Two - Manual (Page 81)

81
Add Fixture Group n …
This adds fixtures in specific groups to the list of selected fixtures. It doesn't add any of their features
to the cue editor, however.
Add Fixture Group n … [To] Preset
Add Fixture Group n … [To] Preset n
These add filters for fixtures in specific groups to the currently selected preset within the cue editor,
or to a specific preset. If the cue doesn't have the preset, it is added. As a convenience to the user, if
any features of the fixtures conflict with features already in the cue, they are removed from the cue,
although the user is free to add them back in manually.
Add Fixture Group n … [To] Submaster p.f
Add Fixture Group n … [To] Submaster p.f @ n
Add Fixture Group n … [To] Submaster p.f @ Full
These add the Dim features of fixtures in specific fixture groups to a dimmer fader at full brightness,
or at a specific brightness (in 0..100).
Add Fixture Group [To] Submaster p.f
Add Fixture Group [To] Submaster p.f @ n
Add Fixture Group [To] Submaster p.f @ Full
These add the Dim features of fixtures in the current fixture group to a dimmer fader at full
brightness, or at a specific brightness (in 0..100).
Add Fixture [To] Submaster p.f
Add Fixture [To] Submaster p.f @ n
Add Fixture [To] Submaster p.f @ Full
These add the Dim feature of the currently selected fixtures to a dimmer fader at full brightness, or at
a specific brightness (in 0..100).
Add Group
Add Group n …
These add the fixtures in the current group, or fixtures in specific groups, to the list of selected
fixtures, and switch to the FIXTURE FEATURES or GROUP FEATURES display. They don't add
any of their features to the cue editor, however.
Add Macro n … [To] Submaster p.f
This adds specific macros to a specific submaster fader.
Add Preset n …
This adds to the list of presets in the cue editor. Only their numbers are added to the cue editor; the
actual feature values they contain remain in the preset objects, not in the cue editor. If any features
conflict with other presets, for HTP parameters the highest value takes precedence, and for LTP
parameters higher-numbered presets take precedence over lower-numbered ones. As a convenience to
the user, if any features conflict with features already in the cue, they are removed from the cue,
although the user is free to add them back in manually. Any presets added by this will have no fixture
filters, so all fixtures mentioned in it will be affected; any presets mentioned that were already in the
cue editor have their fixture filter list cleared.
Add Rotary n …
This adds to the cue editor the features of the current fixture that correspond to specific rotaries,