elektraLite CP100xt Manual Part Two - Manual (Page 89)

89
Clear Rotary n …
This removes from the cue editor the features of the current fixture that correspond to specific
rotaries, numbered from one through eight. It does the same thing as Clear Feature n …, except that it
refers to the features by the rotaries they are connected to, which may be offset by a multiple of eight
for a complex fixture. An error results if the rotaries are connected to dimmers.
Clear Stage Focus (from) All [Fixture]
This turns off Stage Focus for all fixtures in the cue editor. It is an alias for Clear All Stage Focus.
Clear Stage Focus (from) [Fixture]
This turns off Stage Focus for the currently selected fixtures. It does not add any fixtures to the cue
editor, but only affects fixtures already present in the cue editor.
Clear Stage Focus (from) [Fixture] n …
Clear Stage Focus (from) [Fixture] Group
Clear Stage Focus (from) [Fixture] Group n …
These select specific fixtures, the fixtures in the current group, or fixtures in specific groups, and turn
off Stage Focus for them. They do not add any fixtures to the cue editor, but only affect fixtures
already present in the cue editor.
Clear Step
Clear Step n …
These remove the last step, or specific steps. In the latter case, any higher-numbered steps that are not
removed are renumbered.
Color n
Color n @ n
These set color wheel number one, or a specific color wheel, to a specific color number. The
command translates the color wheel number into the appropriate feature number, and the color
number into the corresponding feature value. This may set a color in the current fixture or in all
fixtures in the current group, depending upon what the rotaries are currently connected to. An error
results if the rotaries are connected to dimmers.
Copy All Feature
For each DMX fixture or dimmer that is present in the Cue Editor, along with fixtures that are
selected but not yet present, all features are set according to the values received on the analogous
channels of the DMX input. Also, Stage Focus is turned off for these fixtures.
Copy All Feature [To] Fixture n …
Copy All Feature [To] Group n …
Copy All Rotary [To] Fixture n …
Copy All Rotary [To] Group n …
These copy all features, or the up to eight features currently assigned to rotaries, of the last referenced
fixture that are present in the cue editor to specific target fixtures or fixture groups in the cue editor.
Features that are not present in the source do not cause the corresponding features to be removed from
the target. For the Rotary commands, an error results if the rotaries are connected to dimmers.