elektraLite CP100xt Manual Part Two User Manual
Page 14
14
8) Use the “Chase Speed” & “X-fade Time” faders to set your Step Rate and Cross fade
percentage. If you enter in a zero rate for the chase speed, then this will allow you to manually
operate the chase. In this case, whenever you tap the ‘enter’ key the chase will move one step at
a time.
9) Move the cursor to the “Mode” field and use the “+YES” & “-NO” buttons to set the
desired replay mode.
10) Press STORE-CHASE-n-ENTER to save the chase.
11) Press CHASE-n-GO to start the chase.
STORING THE FRUITS OF YOUR LABOR ONTO SUBMASTERS
1) Press ADD-CUE (or Chase)-TO-SUBMASTER-n.n-ENTER.
This adds the Cue to a specific Submaster page and fader.
i.e.: If you were to press ADD-CUE-1-TO SUBMASTER-7.3-ENTER then Cue number
1 would be placed on Submaster Page 7, Fader number 3.
2) Press CLEAR-ALL-ENTER to clear your fixtures.
3) Go to the specific Submaster Page and raise the fader that you stored stuff to. Voila, there it is!
Well, that’s all folks for the Quick, Quick guide! There is a more detailed Quick Guide added
to the back of this manual but if you want to learn more...read the rest of the book. This should
be more than enough to make you dangerous on this thing.