elektraLite CP100xt Manual Part Two - Manual (Page 92)

92
Copy Fixture Group n … (from) Preset
Copy Fixture Group n … (from) Preset n
These copy features of fixtures in specific groups from the current preset, or a specific preset, into the
cue editor.
Copy Fixture Group n To n …
This copies a fixture group, possibly to multiple targets. It asks for confirmation if any of the targets
already exist.
Copy Fixture Group n … To n
This copies multiple fixture groups to a contiguous range starting with a specified number, asking for
confirmation if any of the targets already exist. The source and target ranges may not overlap.
Copy Macro n To n …
This copies a stored macro, possibly to multiple targets. It asks for confirmation if any of the targets
already exist.
Copy Macro n … To n
This copies multiple stored macros to a contiguous range starting with a specified number, asking for
confirmation if any of the targets already exist. The source and target ranges may not overlap.
Copy Preset
Copy Preset n …
These merge the current preset, or specific presets, into the cue editor. Unlike the Preset commands,
these never clear the cue editor first, even if Solo is on, and they don't crossfade.
Copy Preset n To n …
This copies a stored preset, possibly to multiple targets. It asks for confirmation if any of the targets
already exist.
Copy Preset n … To n
This copies multiple stored presets to a contiguous range starting with a specified number, asking for
confirmation if any of the targets already exist. The source and target ranges may not overlap.
Copy Rotary n To n …
This copies a feature value to one or more other feature values within the currently selected fixtures. It
is like the Copy Feature command, except that it refers to the features by the rotaries they are
connected to, which may be offset by a multiple of eight for a complex fixture. This only copies a
value if the fixture supports both the source and target feature. An error results if the rotaries are
connected to dimmers.
Copy Rotary n … [To] Fixture n …
Copy Rotary n … [To] Group n …
These copy specific features of the current fixture that are present in the cue editor to specific target
fixtures or fixture groups in the cue editor. It is like the Copy Feature command, except that it refers
to the features by the rotaries they are connected to, which may be offset by a multiple of eight for a
complex fixture. An error results if the rotaries are connected to dimmers.