elektraLite CP100xt Manual Part Two - Manual (Page 12)

12
QUICK, QUICK INSTRUCTIONS
For those impatient sods that don’t want to take the time to read this dissertation of a manual word for
word, I will cut to the chase and show you how to do the basics. It is basics, so you will not be a
programming genius after reading this. So if you want to understand and use all the features of the
board and not screw yourself up you’re going to have to read whole manual.
ADD A FIXTURE
1) Press ADD-FIXTURE-ENTER to bring up the “Add Fixture” display.
ADD FIXTURE: Fixture no.: 2
F1 Add
Type: Silverado
2) Move the cursor by using the 4 arrow keys to the immediate right of the display to get the
cursor beside the word “Type”.
3) Then, using the “+YES” or “-NO” keys, scroll through the fixture library to get the fixture
that you want. Press “F1” to put it into your list of fixtures to be used. The “Edit Fixture”
display will appear:
EDIT FIXTURE: Fixture no.: 1 H
F1 Add another Name: _
F2 Delete Type: GoldenScan HPE
DMX Port: 1
4) Use the < & > buttons to move to the “DMX PORT” field and type in the number of the
DMX port that your data cable is hooked into and press ENTER.
5) Use the < & > buttons to move to the “BASE CHANNEL” field and type in the number of
the DMX start address for this fixture and press ENTER.
6) Press: F1 to add another fixture and repeat steps 2 through 5.
7) Press: FIXTURE-n-ENTER to call up the fixture.