Separate the aui appliqué connector plate (show, Store the detached aui appliqué plate, slide ki, To install a 10base2, 10base-t or fiber optic (10b – Allied Telesis AT-TS24TR User Manual
Page 38: Remove the aui appliqué (as described above), Plug the replacement 10base2, 10base-t, or 10ba
TurboStack Hubs with Management
21
5.
Separate the AUI appliqué connector plate (shown in Figure 15) from
the ribbon cable (shown in Figure 16) by rotating the cable 90
°
and
sliding it through the slot in the connector plate.
6.
Store the detached AUI appliqué plate, slide kit screws, washers, and
nuts in a secure container for future use.
To install a 10BASE2, 10BASE-T or fiber Optic (10BASE-FL)
appliqué
1.
Remove the AUI appliqué (as described above).
2.
Plug the replacement 10BASE2, 10BASE-T, or 10BASE-FL appliqué
into the AUI connector, as shown in Figure 17.
Figure 16: AUI Connector and
Ribbon Cable
Assembly
Figure 17: Appliqué
Installation
AUI
connector
Ribbon cable
without
connector plate
Replacement
cover plate
AUI connector
Replacement
appliqué
This manual is related to the following products: