Allied Telesis AT-S26 - Manual (Page 57)

AT-S26 Version 2.0.1 User’s Guide
57
Configuring the RS232 Port
The default settings for the RS232 port on the front panel of the Ethernet
switch are as follows:
❑ Baud rate: 9600
❑ Data bits: 8
❑ Parity: None
❑ Stop bits: 1
❑ Flow control: None
To change the settings for the RS232 port, perform the following
procedure:
1. From the Omega Main Menu, select System Configuration.
The System Configuration menu in Figure 8 on page 43 is displayed.
2. From the System Configuration menu, select Terminal Configuration.
The Terminal Configuration window in Figure 19 is displayed.
Figure 19 Terminal Configuration Window
Terminal Configuration Menu
> VT100-compatible / ANSI
Generic “dumb” terminal
> 8 data bits
7 data bits
> 1 stop bit
2 stop bits
> No parity
Odd parity
Even parity
> Full duplex (echo)
Half duplex (no echo)
Data rate (“baud” rate) ...
Return to System Configuration Menu ...