Allied Telesis AT-S26 - Manual (Page 107)

AT-S26 Version 2.0.1 User’s Guide
107
The VLAN is now configured on the switch. But before you begin to use
the VLAN for network operations, it is recommended that you review the
information in Verifying the VLAN Configuration on page 107.
Verifying the
VLAN
Configuration
Before you begin to use a new VLAN, you should do the following:
❑ Check to be sure that each untagged port belongs to only one
VLAN. If an untagged port belongs to more than one VLAN, you
must remove the port from one of the VLANs. Determining this
might require that you examine the VLAN Configuration window
of each VLAN on the switch.
❑ Check to be sure that the PVID for each untagged port has been
changed to match the VID of its VLAN. This can be determined by
selecting Port to VLAN configuration from the Virtual LANs/QoS
menu.
Once you have verified that the VLAN configuration is correct, you can
begin to use the VLAN for network operations. For an example of
creating a VLAN, refer to the next section.