Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 98)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Virtual Path (VP) Cross Connect
Displays configuration and state information of all point-to-point , point-to-multipoint, or
multipoint-to-multipoint VP cross connect.
Note - The Virtual Path (VP) Cross Connect sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Virtual Channel (VC) Cross Connect
Displays configuration and state information of a bi-directional VC cross connect.
Note - The Virtual Channel (VC) Cross Connect sub-menu option does not display the
correct parameters. Instead, it displays the sub-menu option name as a parameter with a value
of 'noSuchName'.
AAL5 Performance Statistics
Displays performance statistics information associated with an AAL5 virtual channel
connection.
Note - AT-AR240E : The Port Number parameter is not relevant and should be ignored.
Note - AT-AR250E/AT-AR255E : The AAL5 Performance Statistics sub-menu option does
not display the correct parameters. Instead, it displays the sub-menu option name as a
parameter with a value of 'noSuchName'.
PPP Menu
From the PPP menu, you can view and edit Point-to-Point Protocol information such as Link Control
Protocol information, Link Quality Report information, PPP tests, MAC Bridging over PPP, IP over
PPP, and security protocol.
PPP Link Group
PPP Link Status
Displays management information about a particular PPP Link.
PPP Link Configuration
Displays configuration information about a particular PPP Link.
Note - The current firmware version does not allow the Initial MRU parameter to be
configured. Attempting to configure this parameter will not result in an error but the
new value will not be applied.
PN 613-50665 Rev A Page 98 of 257