Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 23)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log into the
CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and description.
Note - Attempting to enter more than 39 characters for the System Contact, System Name,
and System Location parameters may result in a timeout error. If a timeout error occurs, the
switch will have to be restarted causing these parameters to be cleared of any value.
Note - Attempting to set the System Contact, System Name, and System Location parameters
to NULL will result in a general error. However, the parameters will still be temporarily set
to NULL. Once the switch is restarted, the original values will be restored.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway and the
agents.
Note - The current firmware version does not allow the Default Domain Name and the DNS
Server parameters to be configured.
Manager Address Info
Displays the IP address of the management station.
Device Info
Displays general information about the switch.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note - MAC Address Table entries created through a local or telnet management session will
not be visible to AT-View Plus Device Manager until the device is restarted.
Note - The current firmware version does not allow the Port Number parameter to be
configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error".
Reset
Resets the switch.
PN 613-50665 Rev A Page 23 of 257