Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 93)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
ARP Table
Displays the mapping of IP addresses to MAC addresses (the ARP cache) on the router.
Note - The current firmware version does not allow the user to configure the Physical
Address parameter. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: gen Error."
Address Table
Displays the list of IP interfaces and their IP addresses on the router.
Route Table
Displays the IP routing table on the router.
Note - The current firmware version does not allow the user to configure the Destination Port
Number parameter. Attempting to configure this parameter will result in the error messages:
"The error occurred with 'Set' operation. Error: gen Error." or "The error occurred with 'Set'
operation. Error: bad value."
Note - The current firmware version does not allow the following parameters to be
configured:
• Destination Metric 1
• Destination Metric 2
• Destination Metric 3
• Destination Metric 4
• Next Hop Address
• Routing Type
• Route Updated Seconds
• Routing Mask
• Destination Metric 5
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error."
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status and the Default
TTL parameters to be configured. Attempting to configure these will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
ICMP Statistics
Displays ICMP statistics.
PN 613-50665 Rev A Page 93 of 257