Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 68)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note -The current firmware version does not allow the Power A Status and Power B Status
parameters to be configured. Attempting to configure these parameters will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error.".
Line Card Info
Displays information for each line card including line card type and line card temperature.
MAC Address Table
Displays a list of static MAC address configured on the switch.
Note - Valid MIB Set values for the MAC Address Entry Status parameter are 'active', 'not in
service' and 'destroy'. Attempting to set this parameter to any other value will result in error
message: "The error occurred with 'Set' operation. Error: bad value".
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding database
and the spanning tree status.
Forwarding Database
Displays the Forwarding Database table.
Note - It may take some time to retrieve Forwarding Database information. As a result, all
the Forwarding Database parameters may reflect the value 'retry over occurred'. To avoid
this, click on File -> Property -> Polling options and set the Polling Interval parameter to 25
seconds or longer.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but discarded
because either there was a lack of memory or the entry's aging timer expired.
Spanning Tree Info
Displays spanning tree parameters such as spanning tree status and spanning tree version.
PN 613-50665 Rev A Page 68 of 257