Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 69)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - When setting the Spanning Tree Status parameter to 'enabled', connection to the AT-
8400 is temporarily lost. As a result, the following error message appears: "The error
occurred with 'Set' operation. Error: time out occurred.".
Note - Setting the value of the Spanning Tree Version parameter to 'stp' will result in a
permanent loss of connection. To re-establish connection, restart the device.
Statistics
Displays statistics about frames received/transmitted on the switch's ports.
Note - Ports are numbered continuously from top to bottom, across all installed line cards,
starting from the leftmost line card all the way through the rightmost line card.
RMON Menu
From the RMON menu you can view and edit the RMON MIB.
Statistics
Displays traffic statistics in the network segment.
History Control Table
Displays the RMON History table.
Note - The current firmware version does not support the "historyControlTable" MIB object
of RFC1757. As a result, AT-View Plus Device Manager displays the error message "Failed
to get MIB data." when the History Control Table option is selected from the RMON menu.
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Note - Ports are numbered continuously from top to bottom, across all installed line cards, starting
from the leftmost line card all the way through the rightmost line card. This applies to the following
submenu options:
PN 613-50665 Rev A Page 69 of 257