Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 245)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
MGCP
Protocol Info
Displays general information about the protocol.
hen setting the Profile parameter to 'none', the current firmware is able to set
the parameter successfully for the CLI but not for SNMP. As a result, AT-View Plus
Device Manager will continue to display the old value.
From the Port menu, you can view and edit MIB information about the ethernet and voice ports.
Displays ethernet port statistics such as the number of frames received and transmitted on the
port, bytes received and transmitted on the port and port status.
Note - Valid MIB Set values for the Default Port parameter are in the range [1024-
2147483647] inclusive. Attempting to set this parameter to a value outside the valid
range will not result in an error but the new value will not be applied.
Note - W
Note - AT-RG634A: Valid MIB Set values for the Interface parameter are in the
range [1-75] inclusive. But the current firmware version allows the parameter to be
set to more than 75 characters.
Note - AT-RG634A: Valid MIB Set values for the NAT IP Address parameter are in
the range [0-255] inclusive. Attempting to set this parameter to a value outside the
valid range will result in the error message: "No access error."
Note - AT-RG634A: Values displayed on the Protocol Info MIB variable window
may not be consistent with what is set on the device.
Note - AT-RG634A: Valid MIB Set values for the Interface parameter is in the range
[1-75] inclusive. Attempting to set this parameter to a value outside the valid range
will not result to an error message but will cause the device to restart.
Call Agent Info
Displays a list of all call agents available.
Note - AT-RG634A: It may take a while before the correct number of call agents are
displayed in Device Manager.
Port Menu
Utilization
Displays the port's utilization information.
Interface Info
Ethernet
PN 613-50665 Rev A Page 245 of 257