Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 246)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Valid MIB Set values for the Port Speed and Mode parameter of the 100Base-FX
WAN ports should only be '100Mbps full-duplex', '100Mbps half-duplex', and 'auto sense'.
However, the current firmware version allows it to be set to '10Mbps full-duplex' or '10Mbps
half-duplex' as well.
Note - Under the Additional Info sub-m
Note - AT-RG634A: The current firm
Note - AT-RG656BD : W
enu option, if the Port Speed and Mode parameter is
currently set to '100Mbps full-duplex', it cannot be changed to '100Mbps half-duplex'
directly. You will have to set it to some other speed and mode first. This is true for all LAN
and WAN ports.
ware version returns 'No such instance' for the Speed
parameter when the Standard sub-menu option is selected. As a result, no speed is displayed
on the RJ-45 LAN port images.
Statistics
hen a LAN or WAN port is configured to auto-negotiate and is
connected to a 100Mbps full or half duplex port on another device, the current firmware
version returns '10000000' for the Speed parameter under the Standard sub-menu option. As
a result, the speed displayed on the RJ-45 LAN port images is '10' instead of '100'.
Note - The Port Flow Control parameter has a fixed value of 'flow' and cannot be modified.
Note - AT-RG613xx : Changing the value of the Port Speed and Mode parameter will result
in the error message: "The error occurred with 'Set' operation. Error: time out occurred."
However, the new value is still set.
Note - AT-RG634A: Attempting to set the Port Speed and Mode parameter under the
Additional info sub-menu option, will not result in an error but the new value will not be
applied.
Note - AT-RG634A: Selecting the following voice port context sub-menu items will not
launch their corresponding MIB Variable Windows:
Admin Info
Dial Info
Call Forwarding Info
CLI Info
Quality Info
Note - AT-RG634: Valid MIB Set values for the Receive Limit and Transmit Limit
parameters are in the range [0-1000000] inclusive. However, the current firmware version
allows these parameters to be set to more than the maximum value.
Note - AT-RG656BD: The current firmware version returns '???(195)' for the Port Type
parameter of the 100Base-FX WAN port.
PN 613-50665 Rev A Page 246 of 257